Washer Cold Water Valve Leaks

Remove the old washer and slide on the new one.

Washer cold water valve leaks.

It will continue to drip into the tub even days after the washer has been used. If you notice water drips on the wall or floor it s time. A leak originating from the back of the machine could be caused by the water inlet valve. 2 open and close the valve multiple times.

Use a crescent wrench and tighten the nut clockwise at the base of the stem while holding the handle in place. Shutoff valves for the hot and cold water supply to a washing machine can develop leaks over time. If the leak persists before replacing the entire valve try this. It s located in the back of your machine where the hoses connect.

This inlet valve has a standard hose fitting inlet and 2 water outlets facing 45 degrees to the left. There is little that you can do to repair the valve itself but you can clean the two inlet ports to restore full water flow. How to repair a washer shut off valve. Reinstall the packing nut tighten lightly with a wrench don t over tighten at this or any other point and reattach the handle.

In this episode we will repairing an old water valve for a washing machine hose hook up. The water inlet valve on your washing machine is the part that connects the two water hoses to the machine and it controls the flow of both hot and cold water. Try this easy fix if the leak is at the handle. If the water inlet valve is defective the washer may leak fill slowly or not fill at all.

A problem with the valve can cause the washer not to fill properly or not fill at all. To test your valve unplug the washer when the symptom occurs. If it s leaking tighten the packing nut one eighth of a turn at a time until the leak stops. O ring replacement instructions for typical washer shut off valve.

Turn off the water at the house s main shutoff then disassemble the problematic shutoff valve without disconnecting the valve from either the water supply line or the line leading to the. Turn the water back on open the repaired water valve and check for leaks. After the washer has finished its cycle i am getting a small dip that is coming from the area where the washer fills up the tub. I shut off the water to the washer and the drip will continue for about 10 to 20 minutes.

1 to repair certain types of washer water valves first turn off the leaky valve with the handle.