Water Softener Drain Line Running

Water softener install where to drain the water.

Water softener drain line running.

In the garage there is a panel that has a shut off for the water coming into the house and this would be the best place to install the softener. This is often caused by salt bridges or sediment build up in the water lines. A softener drain line must not be connected directly to the waste system but must be emptied into a laundry tray floor drain or properly trapped special outlet preserving an air gap of at least two times the diameter of the drain line but in no case less than 1 1 2 above the top of the receptacle used. Once the water leaves the softener it should branch into two lines.

The main supply line to the rest of the house continues on to the softener. For those of you who have a softener in the garage where do you have the water drain tube go that flushes the system. Drain line best practices on water softener service calls in minnesota we find a wide variety of drain line material being used. The most common reason might be the impossibility to draw brine from the tank.

The industry standard is a polypropylene drain line that is rigid yet flexible. There are a few reasons why your water softener keeps running over and over again. This is to prevent non potable water from flowing backwards possibly mixing and contaminating potable drinking water. Many of the home improvement stores sell big box water softeners and installation kits to get them connected.

Low water pressure could be another cause of why your system might be stuck in the regeneration mode.