Well Drain Back Valve

The spring loaded drain valve operates hydraulicallyand is designed to close thru the water flow velocity in the pipe.

Well drain back valve.

At that point a ball inside the snifter valve moves towards the well piping center away from the outer face or air vent in the valve. The drain back valve snifter valve opens when the submersible pump stops and pressure in the well piping drops. No adjustments are necessary. The drain back valve in the tee placed in the drop pipe in the well below frost level allows the water to drain back to the well.

The drain back valve opens when the submersible pump stops and pressure in the well piping drops. Back to recreational property drainback valve system. The drain back valve is installed five feet or more lower than the elevation of the snifter valve or air inlet valve on the well piping system a maximum vertical distance of 18 feet from the closest drain faucet in the water system. Water begins draining out of the drain back valve.

At the same time because the pump has stopped water starts to drain back out of the water piping and out through the orifice of a drain back valve on the well piping not shown where it returns to the well or lake or to another destination depending on the piping system design. This allows air to enter through a small opening in the valve. The snifter valve allows air into the line to allow the water to drain back to the well. When everything is drained any water in the lines under the house can be ejected at the added outside valve by pushing it out with compressed air from an added drain valve between the well and the inside check valve.

Your water line is always empty when it has drained back. This allows air to enter through a small opening in the snifter valve. The snifter valve allows air into the line to allow the water to drain back to the well. Your water line is always empty when it has drained back.